I'm with the boys: You have done a greeeat job here, mast*r! My 10 2U!
PS: About the missing bricks that thalamic saw before, they are in the upper right zone of the Z, z and 7. I've found two stray bricks in the right side of the end in the middle leg of the m and w; and the upper left inner curve of the ß (UC and lc) can be improved a bit. And finally, I've seeing something strange in the accents of the ì and î, too (look at these, please). Hope to be helpful, compañero. It's a beautiful font.
Simple, yet elegant serif face. I very much like the X, &, and ß. The K,V, and Y are also very good for they show strong character. In this context one could find the R and Q comparatively anaemic. You may test a version of R similar to K. Some of the diacritical marks would deserve more attention: acute, grave, circumflex should bear some semblance to the main theme of the font. All in all, this is another great work. I can imagine these letters carved into rock, or forged from iron. 10/10
Thank you everyone for your kind words - and elmoyenique for his eagle eyes.
I will be working on the stray bricks etc. and I agree with Frodo7 that I should put a bit more effort into the diacritics (as well as reviewing the Q and R).
It's somewhat ironic that I have attempted a design that doesn't require kerning ... just at the point where I have been bought a copy of FontCreator 7.5 as an early Christmas present :)
Now I'll can go back and sort out all my old fonts.
Well … if you're going for opinions, I rather like the middle Q. But like J4s13, I prefer the tail down, as with the J, and might suggest lowering both to the level of the Et's tail? A beautiful design, also. :)
@macossin: I'm sorry, but I no longer allow most of my fonts to be downloaded. In the past I have had people download my work and then pass it off as their own on various free font sites. As I sell most of my recent work on MyFonts.com and Fonts.com I cannot risk that happening again.
I do feel bad that this is not in the true spirit of the FS community - but I try to contribute in other ways.
Block serif
25 Comments
Your virtues are boundless.
;-)
PS: About the missing bricks that thalamic saw before, they are in the upper right zone of the Z, z and 7. I've found two stray bricks in the right side of the end in the middle leg of the m and w; and the upper left inner curve of the ß (UC and lc) can be improved a bit. And finally, I've seeing something strange in the accents of the ì and î, too (look at these, please). Hope to be helpful, compañero. It's a beautiful font.
I will be working on the stray bricks etc. and I agree with Frodo7 that I should put a bit more effort into the diacritics (as well as reviewing the Q and R).
It's somewhat ironic that I have attempted a design that doesn't require kerning ... just at the point where I have been bought a copy of FontCreator 7.5 as an early Christmas present :)
Now I'll can go back and sort out all my old fonts.
I have attempted to tidy up the waifs and strays and have altered the R. However, I can't make my mind up about the Q.
Here are a few alternatives - I'd welcome your views (and any further suggestions).
PS: Be careful with the ¿ glyph because near here there are a lot of lost bricks all together, pal.
@Aloss: The licence is 'All Rights Reserved' which means that it cannot be downloaded ... sorry :(
@RussianGuy: I have made a slight change to the M and N.
@elmoyenique: that was just my angles 'toolkit' showing - gone now.
Only embedding is possible.
Sad to say I don't know how to do it.
I do feel bad that this is not in the true spirit of the FS community - but I try to contribute in other ways.
@p2pnut I prefer the 1st Q.
Please sign in to comment.