Stitch Glitch

Share:
by xX123Xx

Download disabled

The designer of this FontStruction has chosen not to make it available for download from this website by choosing an “All Rights Reserved" license.

Please respect their decision and desist from requesting license changes in the comments.

If you would like to use the FontStruction for a specific project, you may be able to contact the designer directly about obtaining a license.

Any suggestions? Want Uppercase letters? Just comment! \^_^/

10 Comments

Oh this is lovely. Clean, easy to read and hand stitched :)
Yes please, UC, numbers and some more of the 'basic' punctuation would be good.

May I make some suggestions?
Maybe the "s" would look more 'balanced' with the larger opening on the bottom?
What would be the effect with half bricks used to create the full stop/point (to get a gap between top and bottom edges), or use of the small corners or the 'angled half bricks' to create a diamond shape? Or maybe use the quarter rings to make a circular full stop?
Is there a gap in the top curve of the "e"?

Sorry I can't show what I mean and I'm not sure that my monitor shows things as they are because my computer is not working fast enough and my programs need more power than available ATM :(
Comment by Aeolien 26th september 2013
I changed the full stop. Is that what you mean Aeolien?
Comment by xX123Xx 26th september 2013
The "s" looks good :)
Ah, the "e" looks filled,too :)
Yes xX123, the full stop is more suitable for the airy feel of the font.
My ""but"" is this: the "." and "," look a bit large. I think they need to be seen with UC letters, too, to give a better understanding of scale, maybe dropping the "." and "," one square is all that is needed.

As I can't work out your scale/filters, I'll show you some examples of my experiments with FS (and with an embroidery needle thread and fabric)
Comment by Aeolien 26th september 2013
Comment by Aeolien 26th september 2013
Comment by Aeolien 26th september 2013
Very nice. Just a few small points, I think the verticals of the 'i' and 'j' should come up to the x-height - with the dot above. Also, the right side of 'u' is lower than the left and 'y' looks unfinished.

Overall though, 10/10
Comment by p2pnut 27th september 2013
Looking much better :)
Comment by Aeolien 27th september 2013
So.... here.
Comment by xX123Xx 29th october 2013
Should I do Cyrillic? :3
Comment by xX123Xx 30th october 2013
Why not? :D
Comment by Noah F. Ross (winty5) 19th june 2014

Also of Interest

GlyphsApp

Get the world’s leading font editor for OSX.

More from the Gallery

San Pedroby xX123Xx
Technilby xX123Xx
Noraiaby xX123Xx
CUBE30by xX123Xx
wireby ben17
db tempoby beate
DamageControlby geneus1
TRK_softbunkerby redkitten

From the Blog

News

The Numbers Competition

News

16 Years of FontStruct

News

Gridfolk: Interview with Zephram